Home is where the art is

when I wasn't being sick over the xmas weeks, I was cleaning out my house. I pity my poor kids...if I died tomorrow, they would have to sift thru 55 years of crap valuable things to list on ebay.
One of the home projects I've decided to complete after laying dormant for only 14 months...my dining chair seats! I've completed one ! I only have one left to do!
 here's the after....and then the before....and then the easy-peasy step by step...

(before) 

 Choose a sturdy fabric like...upholstery fabric or duck or sailcloth or denim.

1st, Unscrew the seat cushion (turn the chair upside down, and look underneath at the 4 corners for the screws), remove the wood and foam and fabric sandwich from the chair frame and disassemble. Toss the old fabric away. I reused my foam, but if yours is flat after years of butt, go buy new. Like at Joann's or a local foam shop. It's in the yellow pages, ie...411. or ask Google or Siri. 
Then lay the foam on your new fabric, and cut your chair fabric about 3 - 4 inches larger than the foam and wood seat. Yes, save and reuse the wood under the foam. (don't lose those screws!)

2nd ... Be sure to lay the foam on the Wrong Side of the fabric first, evenly with 3 -4 inches all around. Lay the board on top of that, fold an edge of fabric about an inch and gently pull it up to the wood ...start on any edge of the wood, about 1.5" in....and staple. Put a staple about every 2".  I love my new yellow Staple Gun!

3rd...Go all the way around the seat. Start on one side...go to the other side, then the 3rd side, and finish the fourth side. Pull and smooth as you go. You want the foam slightly compressed....but not tight, or the staples will pull out when you sit down. Bad. You can always pull the staples out and start over if you aren't happy when you turn it over and check it.

4th.... the corners are a bit tricky. Pinch the fabric together and artfully fold the corners flat and staple. It is OK to chop a bit of fabric away....but be careful! don't take too much. Be sure you have about 3 - 4 inches to fold over and staple. This is tricky, but you can do it!

Check it out !!
lastly, put it back on the chair, and screw the screws back into the 4 corners underneath the chair. You may have to unscrew the screws a bit so they don't poke you when you sit down. As long as they bite and go thru the wood under the seat, you'll be fine.